Battery stays at 0% when charging.

If an AirVisual Node/Pro is kept disconnected from power for an extended period of time, the battery may not charge normally when AC power is applied again. This problem occurs due to a synchronization mismatch between the battery cell and firmware.

In this case, you may notice that your AirVisual Node/Pro immediately powers off when the charging cable is removed, and the battery icon continuously reads '0%,' even when plugged in.

To return your Node's battery to peak-performance, turn your Node/Pro off for 2 solid minutes, and then leave powered off while the device charges for 30+ minutes. This will allow the battery to reach an important 3.6V threshold, after which the device will begin to behave normally again.

Return to AirVisual Knowledge Base

The number one air cleaning solution for your home.

Lorem ipsum Donec ipsum consectetur metus a conubia velit lacinia viverra consectetur vehicula Donec tincidunt lorem.

Article Resources

Article Resources